How do I hide cables without drilling holes in the wall?

Use adhesive raceways or J-channel strips that attach to the wall surface without drilling. Route cables inside the channel and close the cover. For desk-to-floor drops, a cable sleeve keeps cables bundled without any wall attachment. Adhesive products are removable but may leave marks on painted walls.

What is the best way to hide a laptop charger cable?

Route the charger cable through a cable clip or spine attached to the back edge of the desk, then down through a sleeve or raceway to the power strip. Use a cable clip at the point where the cable leaves the charger brick to prevent the brick from dangling.

How to Hide Desk Cables: Step-by-Step Guide for a Clean Home Office

Hide desk cables in 5 steps: identify cable paths, bundle the desk-to-floor drop, box the power strip, route wall cables, and label everything. Works for any home office or gaming setup.

You can buy every cable sleeve and raceway on the market and still end up with a messy desk.

That's because hiding cables is a routing problem first and a product problem second. The right path makes cables disappear; the wrong path leaves a mess no matter what you bought.

This guide walks through five steps: mapping your cables, taming the power strip, routing the desk-to-floor drop, organizing the desk surface, and labeling everything so future-you doesn't have to guess.

Step 1: Unplug Everything and Map Your Cables

Before touching cable management products, disconnect everything from the power strip. Lay each cable on the desk and trace its path: where does it start, where does it need to go, and what path makes the most sense?

Group cables by destination:

Cables going to the monitor cluster (HDMI, DisplayPort, USB-C, monitor power)
Cables going to desk peripherals (keyboard, mouse, webcam)
Cables going to the power strip (laptop charger, monitor power, hub power)

Step 2: Address the Power Strip First

The power strip is the worst-looking part of any desk setup. Move it off the floor by mounting it under the desk with a power strip mount (most use screws or adhesive strips). Mount it near the desk's back edge so cable drops are short.

Put a cable management box over the power strip if it stays on the floor. The box hides the strip and the cable tangle simultaneously.

Step 3: Route the Desk-to-Floor Drop

With the power strip mounted or in a box, identify the single point where cables drop from desk height to the strip. Route all cables through this point.

Slide a cable sleeve over the bundle. The sleeve should run from about 2 inches below the desk surface to 2 inches above the floor. Secure the top end with a clip or tie to prevent it from sliding.

Step 4: Route Cables Across the Desk

Use cable clips or a cable spine along the back edge of the desk to route surface cables to the drop point. Keep each cable in its own clip path so removing one cable later doesn't require dismantling everything.

For monitor cables: route behind the monitor stand, then along the back of the desk to the drop point. Most people never see the back of a monitor stand — this is where extra cable length goes.

Step 5: Label Each Cable at Both Ends

Before reattaching everything: put a label or color cable tie at each end of every cable. This sounds minor but pays back the 10 minutes spent labeling the first time you need to trace a cable in a managed bundle.

Cable Management Buying Guide - planning guide
Best Cable Management for Desks - product picks
Best Cable Raceways - raceway options